HowTo: Fix inactive linux md raid array state

Материал из support.qbpro.ru
Версия от 18:23, 5 июня 2023; Vix (обсуждение | вклад) (Новая страница: «When you can assemble previously created raid array, but for some reasons it’s run in inactive state + and/or all the drives in md array is marked with: (S)->which means SPARE DRIVE. In my case there was raid5 array from 4 drives with one failed drive. So firstly raid was successfully run with 3 out from 4 drives, but after some terabytes of data copied one of the running drives starts to print errors and finally degraded and stop the array ( in my case i...»)
(разн.) ← Предыдущая версия | Текущая версия (разн.) | Следующая версия → (разн.)

When you can assemble previously created raid array, but for some reasons it’s run in inactive state + and/or all the drives in md array is marked with: (S)->which means SPARE DRIVE.

In my case there was raid5 array from 4 drives with one failed drive. So firstly raid was successfully run with 3 out from 4 drives, but after some terabytes of data copied one of the running drives starts to print errors and finally degraded and stop the array ( in my case it was /dev/md2 )

So what to do:

first investigate:

dmesg
cat /proc/mdstat
mdadm --examine -v /dev/md2
mdadm --detail -v /dev/md2
mdadm --examine -v /dev/sd[b,c,d]3

then try to assemble the all arrays( there was 3 arrays from partitions on that 3 working hard drives):

mdadm --assemble --scan  # it will scan all drives for md magic numbers and will try to run raid arrays found.

then see what’s what:

cat /proc/mdstat
mdadm --detail /dev/md2

I see for /dev/md2 that: array state is: inactive, all 4 drives are marked with (S). So, here is what to do to give back live to this array.

mdadm --stop /dev/md2
mdadm -A --force /dev/md2
voila!

you can do fsck before mounting the partition.

NOTE: in my case , the partition which cause the array fail was reported with wrong timestamp ( in output from mdadm .. -v commands ). So that shows me no data was out of sync and that’s why breavly –force the array activation.